![]() Information About Installing the Software Using install Commandsįrom the Cisco IOS XE 17.9.1 release, IoT routers will be shipped in install mode instead of bundle mode. If the router is booted up in install mode, SMU installation will keep From Cisco IOS XE Release 17.9.x, SMU installation willīe stopped if the router is booted up in bundle mode. SMU installation was supported in both bundle boot and install mode. Install mode requires a reboot of the system. Restrictions for Installing the Software Using install Commands Or downgrade to Cisco IOS XE software versions using a set of install commands. Installing the Software using install Commandsįrom Cisco IOS XE 17.9.1, Cisco IoT routers are shipped in install mode by default. The packages are slightly larger than the. Install mode requires more room in bootflash: for the files. This method provides more control over the software Packages loaded into bootflash, which are read by a nf file. Starting with IOS XE release 17.9.1, a new boot mode called Install mode has been added to the IoT routers. Well known and details are available in your products configuration guide. To upgrade the router to a new version of IOS XE, you would point the "boot system" to a new software image. bin image means that the router would first have to uncompress the image before booting from it. This mode provides a consolidated boot process, using local (hard disk, flash) or remote (TFTP). Bundle boot mode is also known as Consolidatedīoot, and uses a single compressed image. Troubleshooting Software Installation Using install CommandsĬisco IOS XE running on IoT routers has typically made use of the Bundle boot mode. ![]() Information About Installing the Software Using install Commands.Restrictions for Installing the Software Using install Commands.Installing the Software using install Commands.This chapter contains the following sections:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |